AS 1577 為澳洲專門針對腳手架踏板制定的檢測標準，SGS實驗室具備專業的設備，可檢測腳手架踏板的剛度（Stiffness test)，強度（Strength test)，滑移（Sliding test)，防滑（Slip test)等各項測試，為您的腳手架踏板順利出口澳洲提供有力保障。
主要測試項目 Main Testing Items
剛度測試 Stiffness test
強度測試 Strength test
滑移測試 Sliding test
防滑測試 Slip test
性能要求 Properties requirements
2.2.1 Stiffness test When tested in accordance with Appendix A, the deflection of the
plank shall not exceed span/100, to a maximum of 25 mm.
剛度測試的變形量不能超過跨距的1/100，最大不超過25mm
2.2.2 Strength test When tested in accordance with Appendix B, planks shall comply
with the following requirements:
強度測試的要求有如下：
(a) When tested to Paragraph B4(a) to (e), planks shall not show visual signs of
distress, buckling or permanent deformation exceeding span/500. In addition timber
planks shall not show audible signs of distress.
永久變形量不能超過跨距的1/500,且不能在施加力中聽到樣品中發出聲音
(b) When tested to Paragraph B4(f) and (g), the failure load shall be not less than
1.1 Ft, where Ft is the test load, in kilonewtons.
破壞力不能低于1.1倍的Ft
(c) The mode of failure shall be to fail progressively and not break into separate parts.
樣品不能直接斷成兩半
2.2.3 Sliding test When tested in accordance with Appendix C, the force required to
produce sliding shall be not less than 250 N.
滑移力不能小于250N
2.2.4 Slip test When tested in accordance with Appendix D, the plank surface shall
have a static coefficient of friction of not less than 0.7.
靜態摩擦系數不能低于0.7
在線咨詢 
